A Beginners Guide To Services

How To Repair a Garage Door removing the old door is the first step when installing a new garage door, using manufacturer’s instructions as a guide,the old door is carefully removed, this is done by unlatching the door from the pulley system, the panels of the door are then taken apart, and then the tracks unscrewed, one should be careful by removing one panel at a time so that they do not fall on someone The areas where the door is supposed to be installed are then measured, these are; the door-opening height and width, the headroom from the top of opening to ceiling, and the back room which is the length of the garage, having done the proper measurements, the stops temporarily attach to both sides of the opening, making sure they are flush with the inside edge of the door jamb, the bottom piece of the new door is laid out using the sawhorses, if necessary any required weather stripping is attached, any hinges that are necessary are additionally attached and handles lifted to piece Next, using a level in order to set the piece properly, the bottom piece is inserted into the frame of the door, after the piece is set in place, the tap nails partway into each jamb, the nails are bent slightly or slant so that they are secure in place, then using the manufacturer’s instruction, the vertical, curved and horizontal pieces of the track are assembled and then set aside The second panel is then installed on top of the first one, nails are then hammered into the side jambs so that they are well held in place, hinges are the next installed, then the process is repeated according to the number of panels that are necessary, however, it is a requirement that each of the pieces is anchored into the door jamb, this marks the completion of the fourth step undertaken when installing a garage door
What Almost No One Knows About Repairs
after securing all sections, rollers are then installed in the section that does support them after which they are placed in the assembled track, as one goes along the brackets of the tracks are secured, the rollers should not be pressed too tightly against the track to avoid friction which damages the door during usage
The Key Elements of Great Doors
after securing the vertical tracks against the jambs, the horizontal and curved pieces are installed next, previous measurements are used during installation of the horizontal pieces, the tracks should be straight and point 90 degrees away from the opening, springs are then assembled according to manufacturer’s instructions, in order to make the tracks level and parallel, the door is lifted to about half length, in order to attach springs to the pulley, the door is lifted up the remaining distance, that is how a new garage door is opened